Elo TouchSystems MonitorMouse Guía de usuario descargar pdf (Pagina 42)

Controller Data Sheets 37

Next, install a jumper vertically at W1 to select the Interrupt (IRQ). A jumper is

supplied, but may be found in a horizontal, inactive position. See Choosing an

Interrupt (IRQ) for PC-Bus Controllers, page 25. The jumper block positions are

as follows:

Position Interrupt (IRQ)

(from left)

4 5 (factory set)

Remember the Base I/O Port address and IRQ values. You will need them when

updating your CONFIG.SYS file.

Next, verify the Touchscreen Type jumpers. The controller is shipped with a

jumper installed on the pins marked W4. This is the correct setting for E274 5-wire

touchscreens. If you are using an older E270 3-wire touchscreen, install the jumper

on W5 instead.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 53 54

Sin comentarios

Elo TouchSystems MonitorMouse Guía de usuario Pagina 42