Elo TouchSystems MonitorMouse Guía de usuario descargar pdf (Pagina 35)

30 Appendix A - Configuring Your Controller

AccuTouch Serial Controller (E271-140)

Verify the controller’s switch settings are as follows:

Baud Rate

9600 SW1 - OFF SW2 - OFF

4800 SW1 - ON SW2 - OFF

2400 (recommended) SW1 - OFF SW2 - ON

300 SW1 - ON SW2 - ON

8-Bit Data SW3 - OFF

Binary Mode SW4 - ON

Filtered Mode SW5 - ON

Stream Mode SW6 - OFF

2400 baud is recommended to limit the excessive amounts of data at higher baud

rates.

Next, verify the Touchscreen Type jumpers. The controller is shipped with a

jumper installed on the pins marked W1. This is the correct setting for E274 5-wire

touchscreens. If you are using an older E270 3-wire touchscreen, install the jumper

on W2 instead.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 53 54

Sin comentarios

Elo TouchSystems MonitorMouse Guía de usuario Pagina 35