Elo TouchSystems MonitorMouse Guía de usuario descargar pdf (Pagina 15)

10 Chapter 2 - Installing MonitorMouse for OS/2

Serial Touchscreen Controller on PC-Bus System

Change your CONFIG.SYS file as follows:

where <controller> is:

2300 for the IntelliTouch E281-2300 serial controller.

4002 for the IntelliTouch E281{A}-4002 serial controller.

2210 for the AccuTouch E271-2210 serial controller.

140 for the AccuTouch E271-140 serial controller.

<COM port> is the number of the COM port where the serial output of the

touchscreen controller is connected.

<baud rate> matches the switch or jumper settings on the controller.

Here is an example MonitorMouse for OS/2 DEVICE command:

No Mouse

If you do not wish to have a mouse connected, change the "stype=elomou$" flag to

"type=elomou$" on the DEVICE=MOUSE.SYS command.

Disabling the COM Drivers

If your system COM ports are being used by the touchscreen and mouse, REM out

the DEVICE=COM.SYS and DEVICE=VCOM.SYS commands (if present) in

CONFIG.SYS. This prevents the COM drivers from displaying a message saying

the COM ports are unavailable.

If only the touchscreen is using a COM port, move the DEVICE=COM.SYS and

DEVICE=VCOM.SYS commands before the DEVICE=MONMOU01.SYS

command in CONFIG.SYS. Then add the flag (<COM Port>,0,0) to COM.SYS,

where <COM Port> is the same as on the DEVICE=MONMOU01.SYS command.

For example,

Reboot and proceed to Step 4, page 14.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Sin comentarios

Elo TouchSystems MonitorMouse Guía de usuario Pagina 15