Elo TouchSystems MonitorMouse Guía de usuario descargar pdf (Pagina 38)

Controller Data Sheets 33

IntelliTouch PC-Bus Controller (E281{A}-4025)

Verify the controller’s switch settings are as follows:

(From Bottom)

12-Bit Mode SW1 - ON

Reserved SW2 - ON

Stream Mode SW3 - OFF

Reserved SW4 - ON

Z-axis enable SW5 - ON

Reserved SW6 - ON

Reserved SW7 - ON

Reserved SW8 - ON

Next, set the controller’s Base I/O Port address with the W2 and W3 jumpers. W3

selects the high-order address, and W2 the low-order address. The values of the

settings are shown in the following table:

W3 W2

Position Value Position Value

(from top) (in hex) (from top) (in hex)

4 300 8 E0

3 (recommended) 200 7 C0

2 100 6 A0

1 000 5 (recommended) 80

460

340

220

100

To calculate the Base I/O Port address, add the values of the jumpered positions of

W3 and W2. For example, the E281{A}-4025 is usually shipped jumpered for a

Base I/O Port address of 280 hexadecimal. W3 is jumpered in the third position

(200), and W2 is jumpered in the fifth position (80). The address is the sum of

200 + 80, which is 280.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Sin comentarios

Elo TouchSystems MonitorMouse Guía de usuario Pagina 38