Elo TouchSystems MonitorMouse Guía de usuario descargar pdf (Pagina 37)

32 Appendix A - Configuring Your Controller

Next, install a jumper vertically at W1 to select the Interrupt (IRQ). The E281-

4035 is shipped jumpered for IRQ5. See Choosing an Interrupt (IRQ) for PC-Bus

Controllers, page 25. The jumper block positions are as follows:

Interrupt (IRQ)

(from left)

5 (factory set)

Remember the Base I/O Port address and IRQ values. You will need them when

updating your CONFIG.SYS file.

E281-4035 Emulation Modes

The E281-4035 controller is software compatible with the E281A-4025 controller.

If you are using driver software that only supports the AccuTouch E271-141

protocol, the E281-4035 can be set up through switch SW5 (Z-axis disable) for

hardware compatibility with the E271-141 controller.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

Sin comentarios

Elo TouchSystems MonitorMouse Guía de usuario Pagina 37