Elo TouchSystems 1847L Guía de usuario descargar pdf (Pagina 10)

Attaching the L-Brackets

Depending on your mounting scheme, use the L-brackets or the VESA 75/100mm

standard holes located on the back of the kiosk monitor or the 5.5 diameter holes

(only on rear mount). See page 15 for VESA mounting information.

OTE

You will need a screwdriver to attach the L-brackets.

Your kiosk touchmonitor comes with a mounting bracket (C-bracket) attached

at the back. Included are two L-brackets (and four screws) that attach to both

ends of the C-bracket for additional mounting options.

To attach the L-brackets:

1 Lay the monitor face down.

2 Place the long end of the L-bracket against the end of the mounting

C-bracket. Line up the two holes of the L-bracket with the two holes of the

C-bracket. See the illustration below.

3 Place two screws in the holes and with the screwdriver, screw them in to

secure the bracket.

4 Repeat steps 2 and 3 to attach the other L-bracket to the other side of the

mounting bracket.

C bracket

L bracket

2-5

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Sin comentarios

Elo TouchSystems 1847L Guía de usuario Pagina 10